Illumination for Panel Switch does not Come on with Tail Switch ON
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
INSPECTION PROCEDURE
HINT:
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
1. CHECK VEHICLE SIGNAL (OPERATION CHECK)
Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]
Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.
OK:
Light Control Switch
Display
Tail or head
ON
Off
OFF
HINT:
This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.
OK:
Light Control Switch
Display
Tail or head
DIM
Off
BRIGHT
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)