2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Voice is not Recognized

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

INSPECTION PROCEDURE

HINT:
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for T-Connect (w/ T-Connect Function).


1. CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

  1. E268457
    Enter the "Microphone Check" screen. [Refer to Check Mic&Voice Recognition in Operation Check (Click here)]

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← Voice is not Recognized (Aug 2013 – Jul 2014)Cellular Phone Registration Failure (Aug 2013 – Jul 2014) →