REMOVAL
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE FRONT BUMPER LOWER COVER |
Remove the clip, 5 bolts and front bumper lower cover.
| 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts and No. 1 engine under cover.
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
- Torque:
- 34 N*m{ 347 kgf*cm , 25 ft.*lbf }
| 4. REMOVE OIL PRESSURE SWITCHING VALVE ASSEMBLY |
Disconnect the oil pressure switching valve connector.
Remove the bolt and oil pressure switching valve.

