2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT OIL PRESSURE SWITCHING VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    13 to 17 Ω

    If the result is not as specified, replace the oil pressure switching valve assembly.

  1. A231900E01
    Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check that the operating sound of the oil pressure switching valve can be head.

    NOTICE:
    1. These tests must be performed within 10 seconds to prevent the coil from burning out.
    2. Always turn the voltage on and off on the battery side, not the oil pressure switching valve side.

    If the result is not as specified, replace the oil pressure switching valve.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →