2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here)

      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD with Entry and Start System)
      B
      CAN DTC is output (for LHD without Entry and Start System)
      C
      CAN DTC is output (for RHD with Entry and Start System)
      D
      CAN DTC is output (for LHD without Entry and Start System)
      E


    B.

    C.

    D.

    E.
    A

    4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Check if the LIN communication system is functioning normally.

      Result 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B


    B.
    A

    5.CHECK FOR DTC*
    1. Clear the DTCs. (Click here)

    2. Recheck for DTCs.

      Result 
      Result
      Proceed to
      No DTCs are output
      A
      DTC B2311 is output
      B
      DTC B2312 is output
      B
      DTC B2313 is output
      B


    B.
    A

    6.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B


    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    8.REPAIR OR REPLACE
      Result 
      Result
      Proceed to
      Door window regulator replaced or removed/installed
      A
      Door window regulator not replaced or removed/installed
      B

    B.
    A

    9.PERFORM INITIALIZATION
    1. Initialize the power window regulator motor (Click here).

    NEXT

    10.CONFIRMATION TEST
      NEXT

      ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →