2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve assembly.

  1. A099422E19
    Connect the positive (+) lead of the battery to terminal 1 and negative (-) lead to terminal 2 and check the movement of the spool valve.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) voltage is applied
    Valve moves in left arrow direction shown in illustration
    Battery positive (+) voltage is cut off
    Valve moves in right arrow direction shown in illustration

    Text in Illustration 
    *1
    Spool Valve
    If the result is not as specified, replace the oil control valve assembly.
    If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →