2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve.

  1. A223678E01
    Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check the movement of the valve.

    OK:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Battery positive (+) voltage is applied
    Valve moves in direction of left arrow shown in illustration
    Battery positive (+) voltage is cut off
    Valve moves in direction of right arrow shown in illustration

    If the result is not as specified, replace the camshaft timing oil control valve.
    If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →