HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the engine immobiliser system.
- Use these procedures to troubleshoot the engine immobiliser system.
- *: Use the intelligent tester.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
- If the voltage is below 11 V, recharge or replace the battery before proceeding.
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the LIN communication system is functioning normally.
Result Result
Proceed to
LIN DTC is not output
A
LIN DTC is output
B
|
|||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and make a note of any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here). Based on the DTCs output above, try to cause the output of the same ECD system*1, SFI system*2, steering lock system or engine immobiliser system DTC by reproducing the symptoms indicated by the DTC.
- *1: for 1KD-FTV
- *2: for 1GR-FE, 2TR-FE
Result Result
Proceed to
DTC is not output
A
SFI system DTC is output (for 2TR-FE)
B
SFI system DTC is output (for 1GR-FE)
C
ECD system (w/ DPF) DTC is output
D
ECD system (w/o DPF) DTC is output
E
Steering lock system DTC is output
F
Engine immobiliser system DTC is output
G
- *1: for 1KD-FTV
|
|||||
|
|||||
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||