2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B278A Short to GND in Immobiliser System Power Source Circuit

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

This DTC is stored when the engine switch power source supply line is open or shorted.
DTC Code
DTC Detection Condition
Trouble Area
B278A
The engine switch power source supply line is open or shorted.
  1. Harness or connector
  1. Engine switch
  1. Certification ECU

WIRING DIAGRAM

B153714E21

INSPECTION PROCEDURE

NOTICE:
Before replacing the certification ECU, refer to the Service Bulletin.


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)
  1. Disconnect the G38 ECU connector.

  1. Disconnect the G36 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G38-28 (VC5) - G36-14 (VC5)
    Always
    Below 1 Ω
    G38-36 (AGND) - G36-8 (AGND)
    G38-28 (VC5) or G36-14 (VC5) - Body ground
    Always
    10 kΩ or higher
    G38-36 (AGND) or G36-8 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK CERTIFICATION ECU

  1. B226518E03
    Using an oscilloscope, check the waveform.
    Measurement Condition 
    Item
    Content
    Tester Connection
    G36-14 (VC5) - G36-8 (AGND)
    Tool Setting
    2 V/DIV., 20 ms./DIV.
    Condition
    Engine switch off, key not in cabin, and 30 seconds or less after engine switch pushed

    OK:
    Waveform is output normally (refer to illustration).

    Text in Illustration 
    *a
    Component with harness connected
    (Engine Switch)

    HINT:
    If replacing the Engine Switch, refer to the procedures below.
    1. for 1GR-FE (for LHDClick here)
    2. for 1GR-FE (for RHDClick here
    3. for 2TR-FEClick here)
    4. for 1KD-FTV (for LHDClick here)
    5. for 1KD-FTV (for RHDClick here)



NG
REPLACE CERTIFICATION ECU
OK

REPLACE ENGINE SWITCH


← B2784 Antenna Coil Open / Short (from Aug 2013)B2790 ID BOX EEPROM Malfunction (from Aug 2013) →