2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Headlight Signal Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM

B246536E02

INSPECTION PROCEDURE

NOTICE:
First check that the low beam headlights operate normally.


1. CHECK HEADLIGHT CLEANER CONTROL RELAY (HDLO VOLTAGE)

  1. E196647E05
    Disconnect the A38 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A38-1 (HDLO) - Body ground
    Headlight dimmer switch in head
    11 to 14 V
    A38-1 (HDLO) - Body ground
    Headlight dimmer switch not in head
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Cleaner Control Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Headlight Signal Circuit (Aug 2013 – Jul 2014)Rear Wiper does not Operate (Aug 2013 – Jul 2014) →