Headlight Signal Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The headlight cleaner control relay detects the low beam headlights status.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- First check that the low beam headlights operate normally.
| 1. CHECK HEADLIGHT CLEANER CONTROL RELAY (HDLO VOLTAGE) |
 |
- Disconnect the A38 headlight cleaner control relay connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
A38-1 (HDLO) - Body ground
|
Headlight dimmer switch in head
|
11 to 14 V
|
A38-1 (HDLO) - Body ground
|
Headlight dimmer switch not in head
|
Below 1 V
|
Text in Illustration
*a
|
Front view of wire harness connector (to Headlight Cleaner Control Relay)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|