2013-2015 Land Cruiser Prado · Service Manual Brake

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL VACUUM PUMP ASSEMBLY
  1. Align the matchmarks and install the vacuum pump to the generator with the 4 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


2. INSTALL GENERATOR WITH VACUUM PUMP ASSEMBLY

HINT:
Refer to the instructions for installation of the generator with vacuum pump (Click here).


3. CHECK VACUUM PUMP ASSEMBLY
  1. Disconnect the vacuum hose from the vacuum pump.

  1. C106115E03
    Connect the hose of a vacuum gauge to the pump.
    Text in Illustration 
    *1
    Vacuum Gauge
    *2
    Plug

  1. Insert a plug into the other hose of the gauge.

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, measure the negative pressure of the pump.

    Standard negative pressure:
    More than 86.7 kPa (650 mmHg, 26 in.Hg)

  1. Remove the gauge from the pump.

  1. Connect the hose to the pump with the clip.

← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →