INSTALLATION
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL GENERATOR ASSEMBLY |
Temporarily install the generator with the 2 bolts.
Connect the vacuum pump oil outlet hose.
Install 2 new gaskets and the vacuum pump oil inlet hose with the union bolt.
- Torque:
- 14 N*m{ 140 kgf*cm , 10 ft.*lbf }
Connect the vacuum pump hose.
Attach the vacuum pump oil inlet hose to the cord clip.
Install the generator wire with the nut.
- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Install the terminal cap.
Connect the generator connector.
| 2. CONNECT COOLER COMPRESSOR ASSEMBLY |
Temporarily install the cooler compressor with the 2 bolts.

Temporarily install the idle pulley bracket with the 4 bolts.
Tighten the 6 bolts in the sequence shown in the illustration.
- Torque:
- for bolt A:
- 45 N*m{ 459 kgf*cm , 33 ft.*lbf }
- except bolt A:
- 25 N*m{ 250 kgf*cm , 18 ft.*lbf }
Connect the wire harness with the bolt.
- Torque:
- 13 N*m{ 131 kgf*cm , 9 ft.*lbf }
Connect the cooler compressor connector.
| 3. INSTALL FAN AND GENERATOR V BELT |
Install the fan and generator V belt (Click here).
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
