2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE FRONT BUMPER COVER LOWER
  1. Remove the clip, 5 bolts and front bumper cover lower.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A224743
    Remove the 4 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.


4. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


A223311E01
Text in Illustration 
*1
Reservoir Cap
*2
Radiator Cap
*3
Cylinder Block Drain Cock Plug
*4
Radiator Drain Cock Plug

  1. G038197E02
    Install a vinyl hose to the radiator side.
    Text in Illustration 
    *1
    Vinyl Hose

  1. G038198E02
    Install a vinyl hose to the engine side.
    Text in Illustration 
    *1
    Vinyl Hose

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap and drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the cylinder block drain cock plug and drain the coolant from the engine.


5. REMOVE FAN AND GENERATOR V BELT

  1. A099194E01
    Use the hexagonal part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the V belt. Then remove the V belt.

    NOTICE:
    When removing the V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


6. DISCONNECT VANE PUMP ASSEMBLY

  1. A218388
    Remove the bolt and disconnect the pressure feed tube.

  1. A218387
    Disconnect the 2 connectors.

  1. Remove the 2 bolts and disconnect the vane pump.

    HINT:
    It is not necessary to completely remove the vane pump. With the hoses connected to the vane pump, hang the vane pump on the vehicle body with a rope.


7. DISCONNECT NO. 2 RADIATOR HOSE

  1. A223317
    Disconnect the No. 2 radiator hose.


8. REMOVE WATER INLET

  1. A226811
    Remove the bolt and 2 nuts, and then remove the water inlet.

  1. Remove the gasket from the timing chain cover.


9. REMOVE THERMOSTAT

  1. A223318
    Remove the thermostat from the timing chain cover.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →