2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(Click here)

4. REMOVE NO. 1 HEATER TO REGISTER DUCT

B238230
  1. Remove the 4 screws <A> and No. 1 heater to register duct.


5. REMOVE NO. 2 HEATER TO REGISTER DUCT

HINT:
Use the same procedure described for the No. 1 heater to register duct.


6. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

B238232
  1. Remove the screw <A>.

  1. Detach the 2 claws and remove the No. 1 side defroster nozzle duct.


7. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

HINT:
Use the same procedure described for the No. 1 side defroster nozzle duct.


8. REMOVE DEFROSTER NOZZLE ASSEMBLY

B238226
  1. Remove the 4 screws <A> and defroster nozzle.


9. REMOVE NAVIGATION ANTENNA ASSEMBLY

  1. B239305
    Detach the 2 clamps.

  1. Remove the 2 screws and navigation antenna assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →