2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

BASIC INSPECTION

Troubleshooting · Vehicles built from Aug 2013

HINT:
When a malfunction cannot be confirmed by the DTC (Diagnostic Trouble Code) check, troubleshooting should be performed on all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.


1.CHECK BATTERY VOLTAGE

    NOTICE:
    Perform this check with the engine stopped and the ignition switch off.

    Standard Voltage:
    Result 
    Result
    Proceed to
    11 V or more
    OK
    Below 11 V
    NG


NG.
OK

2.CHECK IF ENGINE WILL CRANK

    NG.
    OK

    3.CHECK AIR FILTER
    1. Visually check that the air filter is not excessively contaminated with dirt or oil.


    NG.
    OK

    4.CHECK FUEL QUALITY
    1. Check that only diesel fuel has been used.

    2. Check that the fuel does not contain any impurities.


    NG .
    OK

    5.CHECK FUEL FOR AIR

      NG.
      OK

      6.CHECK FUEL PIPES AND HOSES
      1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


      NG.
      OK

      7.CHECK FUEL FILTER ELEMENT ASSEMBLY FOR BLOCKAGE

        NG.
        OK

        8.CHECK ENGINE OIL

          NG.
          OK

          9.CHECK ENGINE COOLANT

            NG.
            OK

            10.CHECK IDLING SPEED AND MAXIMUM SPEED

              NG.
              OK

              11.CHECK DIAGNOSTIC CIRCUIT

                NG.
                OK

                12.CHECK VACUUM PUMP

                  NG.
                  OK

                  ← CHECK FOR INTERMITTENT PROBLEMS (from Aug 2014)PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014) →