Security Indicator Light Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- When the engine immobiliser system is set, the security indicator flashes continuously, but does not illuminate if the engine immobiliser system is not set.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Before replacing the certification ECU, refer to the Service Bulletin.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT) |
Check that the security indicator light illuminates when operating it with the Active Test (Click here).
Entry&Start Tester Display
Test Part
Control Range
Diagnostic Note
Immobiliser Indicator
Security indicator light
ON/OFF
The test is possible when the following conditions are met: - The key is in the cabin.
- The engine switch is on (IG).
- OK:
- Security indicator light can be turned on and off using the intelligent tester.
- The key is in the cabin.
|
|
||||
| OK | ||
| ||
| 2. INSPECT SECURITY INDICATOR LIGHT ASSEMBLY |
Remove the security indicator light assembly (Click here).

Apply battery voltage between the terminals of the security indicator light assembly and check that the security indicator light illuminates.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 2 (LP)
Battery negative (-) → 5 (E)
Security indicator light illuminates
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - CERTIFICATION ECU AND BODY GROUND) |
Disconnect the H23 light connector.
Disconnect the G38 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H23-2 (LP) - G38-2 (IND)
Always
Below 1 Ω
H23-5 (E) - Body ground
Always
Below 1 Ω
H23-2 (LP) or G38-2 (IND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
