2013-2015 Land Cruiser Prado · Service Manual Drivetrain

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to How to Troubleshoot ECU Controlled Systems in the Introduction section (Click here).

    NEXT

    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    4.CONNECT INTELLIGENT TESTER TO DLC3*
      NEXT

      5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to DTC Check / Clear (Click here).

      NEXT

      6.VISUAL INSPECTION
        NEXT

        7.SETTING CHECK MODE DIAGNOSIS*
        1. Refer to Check Mode Procedure (Click here).

        NEXT

        8.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to Road Test (Click here).

          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B


        B.
        A

        9.SYMPTOM SIMULATION
        1. Refer to Electronic Circuit Inspection Procedure (Click here).

        NEXT

        10.DTC CHECK*
        1. Refer to DTC Check / Clear (Click here).

          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B


        B.
        A

        11.BASIC INSPECTION
        1. Refer to Park/Neutral Position Switch (Click here).

        2. Refer to Shift Lever Assembly (Click here).


        NG.
        OK

        12.MECHANICAL SYSTEM TESTS
        1. Refer to Mechanical System Tests (Click here).


        NG.
        OK

        13.HYDRAULIC TEST
        1. Refer to Hydraulic Test (Click here).


        NG.
        OK

        14.MANUAL SHIFTING TEST
        1. Refer to Manual Shifting Test (Click here).


        NG.
        OK

        15.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to Problem Symptoms Table (Click here).


        NG.
        OK

        16.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to Problem Symptoms Table (Click here).


        NG.
        OK

        17.PROBLEM SYMPTOMS TABLE CHAPTER 3
        1. Refer to Problem Symptoms Table (Click here).

        NEXT

        18.PART INSPECTION

          NG.
          OK

          19.DTC CHART
          1. Refer to Diagnostic Trouble Code Chart (Click here).

          NEXT

          20.CIRCUIT INSPECTION
            NEXT

            21.IDENTIFICATION OF PROBLEM
              NEXT

              22.REPAIR OR REPLACE
                NEXT

                23.CONFIRMATION TEST
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)ROAD TEST (from Aug 2013) →