INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP HOUSING |
Using a micrometer, measure the outer diameter of the vane pump shaft.

Text in Illustration *a
Outer Diameter
*b
Inner Diameter
Using a vernier caliper, measure the inner diameter of the vane pump front housing bush.
Calculate the oil clearance.
Oil clearance = Inner diameter of the bush - Outer diameter of the shaft- Maximum oil clearance:
- 0.07 mm (0.00276 in.)
| INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE |
Using a micrometer, measure the thickness of the vane pump plates.

- Standard thickness:
- 1.397 to 1.403 mm (0.0550 to 0.0552 in.)
Text in Illustration *a
Thickness
Using a feeler gauge, measure the clearance between side of the vane pump rotor groove and the vane pump plates.

- Maximum clearance:
- 0.033 mm (0.0013 in.)
If the clearance is more than the maximum, replace the vane pump.Text in Illustration *1
Feeler Gauge
| INSPECT FLOW CONTROL VALVE |
Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve hole under its own weight.
If the value does not fall smoothly into the hole, replace the vane pump.
Check the flow control valve for leakage. Close one of the holes and apply compressed air at 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi) into the hole on the opposite side and confirm that air does not come out from the end holes.

If air leaks, replace the vane pump assembly.Text in Illustration *a
Compressed Air
| INSPECT FLOW CONTROL VALVE COMPRESSION SPRING |
Using a vernier caliper, measure the free length of the flow control valve compression spring.

- Minimum free length:
- 32.3 mm (1.28 in.)
| INSPECT PRESSURE PORT UNION |
If the union seat in the pressure port union is severely damaged, it may cause fluid leakage. If the union seat is damaged, replace the vane pump assembly.
