2013-2015 Land Cruiser Prado · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE SUCTION PORT UNION

  1. C121998
    Remove the bolt and power steering suction port union.

  1. Using a screwdriver, remove the O-ring from the power steering suction port union.


2. REMOVE FLOW CONTROL VALVE

  1. C106278
    Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.


3. REMOVE VANE PUMP REAR HOUSING

  1. C106279
    Remove the 4 bolts and vane pump rear housing.

  1. Remove the gasket.

  1. Remove the 2 O-rings from the vane pump rear housing.


4. REMOVE VANE PUMP REAR SIDE PLATE
  1. Remove the wave washer from the vane pump rear side plate.

  1. C106287
    Remove the vane pump rear side plate.


5. REMOVE VANE PUMP CAM RING

  1. C106286
    Remove the vane pump cam ring.


6. REMOVE VANE PUMP ROTOR
  1. Remove the 10 vane pump plates.

  1. C106281
    Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft.

  1. Remove the vane pump rotor.


7. REMOVE VANE PUMP SHAFT
  1. Remove the vane pump shaft from the vane pump front housing.


8. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C106280E02
    Using a screwdriver, pry out the vane pump housing oil seal.
    Text in Illustration 
    *1
    Cloth

    NOTICE:
    Be careful not to damage the vane pump front housing.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →