2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Aug 2013

NOTICE:
Enter "Signal Check" from the "DTC Check" screen displayed on the intelligent tester to clear the output DTCs (both present and past).

HINT:
  1. DTCs can be stored more sensitively in check mode than in normal diagnosis mode.
  2. Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.


CHECK MODE PROCEDURE (Using the Intelligent Tester)
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the intelligent tester on.

  5. Select "Signal Check", and proceed with checking using the intelligent tester.

← DTC CHECK / CLEAR (from Aug 2014)DATA LIST / ACTIVE TEST (from Aug 2013) →