DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2013
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / SRS Airbag / Data List.
According to the display on the intelligent tester, read the Data List.
SRS Airbag Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Left Side Buckle SW
*1
*3
Buckle Switch LH/
Unset: Seat belt is not fastened
Set: Seat belt is fastened
NG: Data is not determined
Unset/Set
-
Right Side Buckle SW
*2
*3
Buckle SW RH/
Unset: Seat belt is not fastened
Set: Seat belt is fastened
NG: Data is not determined
Unset/Set
-
Driver Buckle SW
Driver side seat belt buckle switch / Unset, Set or NG
Unset/Set
-
Display Type Information
Display Type Information/
LR: Display is indicated by LH/RH
DP: Display is indicated by Driver/Passenger
DP
-
Display Type Information
*3
Display Type Information/
LR: Display is indicated by LH/RH
DP: Display is indicated by Driver/Passenger
LR
-
Number of Past DTC
Number of Past DTCs/
Min.: 0, Max.: 255
0
-
- *1: for LHD
- *2: for RHD
- *3: w/ Side Airbag
- *1: for LHD