ABS Warning Light Remains ON
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.If any of the following is detected, the ABS warning light remains on:
- The skid control ECU connector is disconnected from the skid control ECU.
- There is a malfunction in the skid control ECU internal circuit.
- There is an open in the harness between the combination meter and the skid control ECU.
- The anti-lock brake system is defective.
- The voltage at terminal IG1 is high.
- HINT:
- In some cases, the intelligent tester cannot be used when the skid control ECU is abnormal.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. CHECK TERMINAL VOLTAGE (IG1) |
Disconnect the A6 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A6-34 (IG1) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) |
Disconnect the A6 skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A6-1 (GND1) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 5. READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| ABS Warning Light |
ABS warning light / ON or OFF |
OFF |
- |
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List (Click here).
| Tester Display |
Test Part |
Control Range |
Diagnostic Note |
| ABS Warning Light |
ABS warning light |
Warning light ON/OFF |
Observe the combination meter. |
| Result |
Proceed to |
|
| Data List Display |
Data List Display when Performing Active Test ON/OFF Operation |
|
| ON |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
| OFF |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
|
|
||||
| A | ||
| ||
