2013-2015 Land Cruiser Prado · Service Manual Brake

C1203 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The ABS specification information is determined based on the engine specification information that the brake actuator assembly (skid control ECU) receives from the ECM via CAN communication and the door information (for 3 Door or 5 Door) stored by the brake actuator assembly (skid control ECU).
DTC Code
DTC Detection Condition
Trouble Area
C1203
The engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
  1. ECM
  2. Brake actuator assembly

INSPECTION PROCEDURE


1. CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
  1. Check that the proper ECM and brake actuator assembly (skid control ECU) are installed.

    Result 
    Result
    Proceed to
    Proper ECUs are installed
    A
    Proper ECUs are not installed
    B



B
REPLACE ECUS WITH PROPER ONES
A


2. PERFORM CALIBRATION
  1. Perform Calibration (Click here).


NEXT


3. CHECK FOR DTC
  1. Check for DTC (Click here).

    Result 
    Result
    Proceed to
    DTC C1203 is output
    A
    DTC C1203 is not output
    B



B
END
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C0278 Open in ABS Solenoid Relay Circuit (+ C0279) (from Aug 2014)C1203 ECM Communication Circuit Malfunction (from Aug 2014) →