Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the ECU to output the DTCs by blinking the ABS warning light and slip indicator light.
WIRING DIAGRAM
HINT:
When the warning lights continue to blink, a ground short in the wiring of terminal 13 (TC) of the DLC3 or an internal ground short in one or more ECUs is suspected.
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform calibration (Click here).
1. CHECK CAN COMMUNICATION SYSTEM
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result
Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A
2. INSPECT DLC3
Measure the voltage according to the value(s) in the table below.