2013-2015 Land Cruiser Prado · Service Manual Suspension

Tire Pressure Warning Light Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If the tire pressure warning ECU and receiver detects a disconnected connector or an open circuit between the tire pressure warning ECU and receiver and combination meter assembly, the tire pressure warning light blinks for 1 minute, and then remains on after the ignition switch ON.

WIRING DIAGRAM

C171956E08

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECU)
  1. Disconnect the tire pressure warning ECU and receiver R41 connector.

  1. Disconnect the combination meter assembly G7 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R41-5 (IND) - G7-16 (TIRE)
    Always
    Below 1 Ω
    R41-5 (IND) or G7-16 (TIRE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by using the GTS.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling.

    OK:
    The tire pressure warning light turns on or off in accordance with the GTS operation.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)


← C2198/98 Initialization Switch (for Test Mode DTC) (from Aug 2014)Tire Pressure Warning Light Circuit (from Aug 2014) →