2013-2015 Land Cruiser Prado · Service Manual Suspension

C2198/98 Initialization Switch (for Test Mode DTC)

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.
DTC No.
DTC Detection Condition
Trouble Area
C2198/98
Test mode procedure is performed.
  1. Tire pressure warning reset switch
  2. Harness or connector
  3. Tire pressure warning ECU and receiver

WIRING DIAGRAM

C249283E16

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.


1. INSPECT TIRE PRESSURE WARNING RESET SWITCH
  1. Remove the tire pressure warning reset switch (Click here).

  1. Inspect the tire pressure warning reset switch (Click here).



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)
  1. Disconnect the tire pressure warning reset switch G153 connector and the tire pressure warning ECU and receiver R41 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R41-7 (CLSW) - G153-1
    Always
    Below 1 Ω
    R41-7 (CLSW) or G153-1 - Body ground
    Always
    10 kΩ or higher
    G153-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)


← C2198/98 Initialization Switch (for Test Mode DTC) (Aug 2013 – Jul 2014)Tire Pressure Warning Light Circuit (Aug 2013 – Jul 2014) →