When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also receives engine switch signals via this circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
Disconnect the G116 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G116-8 (IG) - Body ground
Engine switch on (IG)
11 to 14 V
Text in Illustration
*a
Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G116-11 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)