Actuator Power Source Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This is the power source for the power tilt and power telescopic steering column system.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
|
 |
- Disconnect the G116 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
G116-2 (+B) - Body ground
|
Always
|
11 to 14 V
|
Text in Illustration
*a
|
Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
|
 |
- Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
G116-11 (GND) - Body ground
|
Always
|
Below 1 Ω
|
Text in Illustration
*a
|
Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
|