2013-2015 Land Cruiser Prado · Service Manual Steering

B2624 Vehicles Speed Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the CAN communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the CAN communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the CAN communication bus to prevent improper operation of the auto away/return function during driving.
DTC Code
Detection Condition
Trouble Area
B2624
Either condition is met:
  1. The auto away function is disabled with the last vehicle speed signal* at 10 km/h (6 mph) or more.
  2. Vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.
  1. CAN communication system
  2. Meter/gauge system
  3. Multiplex tilt and telescopic ECU

HINT:
*: If the engine switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


INSPECTION PROCEDURE


1. CHECK OTHER DTC OUTPUT
  1. Check if DTC B2621 is output (Click here).

    Result 
    Result
    Proceed to
    DTC B2621 is not output.
    A
    DTC B2621 is output.
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE (Click here)
A


2. READ VALUE USING INTELLIGENT TESTER (FREEZE SPEED INFO)
  1. Use the Data List to check if the speed signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Freeze Speed Info
    Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Stop → Drive → Stop
    0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph)
    Result 
    Result
    Proceed to
    Tester indication is normal.
    A
    Tester indication is abnormal.
    B

    HINT:
    A vehicle speed of 3 km/h (2 mph) or more may be displayed on the intelligent tester screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in the vehicle signal input via the CAN communication bus and is not a malfunction.



B
GO TO METER/GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)


← B2624 Vehicles Speed Malfunction (Aug 2013 – Jul 2014)Actuator Power Source Circuit (Aug 2013 – Jul 2014) →