FREEZE FRAME DATA
Troubleshooting · Vehicles built from Aug 2013
| FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and check the freeze frame data by following the prompts on the intelligent tester screen.
Tilt & Telescopic Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Tilt Position
Current tilt position data/min.: 0, max.: 65535
28672 to 36864
-
Telesco Position
Current telescopic position data/min.: 0, max.: 65535
28672 to 36864
-
Tilt Return Position
Memorized tilt return position data/min.: 0, max.: 65535
28672 to 36864
-
Telesco Return Position
Memorized telescopic return position data/min.: 0, max.: 65535
28672 to 36864
-
Tilt Up Switch
Input state of tilt up by manual switch/ON or OFF
ON: Tilt up activated by manual switch
OFF: Tilt up not activated by manual switch
-
Tilt Up SW(CAN)
Input state of tilt up by manual switch/ON or OFF
ON: Tilt up activated by manual switch
OFF: Tilt up not activated by manual switch
-
Tilt Down Switch
Input state of tilt down by manual switch/ON or OFF
ON: Tilt down activated by manual switch
OFF: Tilt down not activated by manual switch
-
Tilt Down SW(CAN)
Input state of tilt down by manual switch/ON or OFF
ON: Tilt down activated by manual switch
OFF: Tilt down not activated by manual switch
-
Telesco Short Switch
Input state of telescopic short by manual switch/ON or OFF
ON: Telescopic short activated by manual switch
OFF: Telescopic short not activated by manual switch
-
Telesco Short SW(CAN)
Input state of telescopic short by manual switch/ON or OFF
ON: Telescopic short activated by manual switch
OFF: Telescopic short not activated by manual switch
-
Telesco Long Switch
Input state of telescopic long by manual switch/ON or OFF
ON: Telescopic long activated by manual switch
OFF: Telescopic long not activated by manual switch
-
Telesco Long SW(CAN)
Input state of telescopic long by manual switch/ON or OFF
ON: Telescopic long activated by manual switch
OFF: Telescopic long not activated by manual switch
-
T&T Manual SW Data
Voltage data of manual switch/min.: 0.00 V, max.: 4.99 V
Neutral position: Below 0.2 V
Tilt up: 1.67 to 2.13 V
Tilt down: 0.54 to 0.74 V
Telescopic contract: 1.08 to 1.40 V
Telescopic extend: 2.22 to 2.77 V
-
Power Source Voltage
Voltage data of power supply/min.: 0.00 V, max.: 19.99 V
11 to 14 V
-
Freeze Speed Info
Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Actual vehicle speed
-
IG Switch (CAN)
Communication state of engine switch/ON or OFF
ON: Communication normal
OFF: Communication interrupted
-
IG Switch
Input state of engine switch/ON or OFF
ON: Input signal normal
OFF: Input signal interrupted
-
Receive from Meter
Communication state of combination meter signal/OK or Interpt
OK: Communication normal
Interpt: Communication interrupted
-
Receive from Seat ECU
Communication state of position control ECU signal/OK or Interpt
OK: Communication normal
Interpt: Communication interrupted
-
Receive from Combi
Communication state of combination switch ECU signal/OK or Interpt
OK: Communication normal
Interpt: Communication interrupted
-
J/B
Communication state of main body ECU signal/OK or Interpt
OK: Communication normal
Interpt: Communication interrupted
-
Handle Position
Steering wheel position signal/Away or Return
Away: Steering wheel in away position
Return: Steering wheel in return position
(Except remote start)
-
The Number of DTCs
Number of stored diagnostic trouble codes/min.: 0, max.: 255
Actual number of stored diagnostic trouble codes
-