2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When a key switch is pushed: 1) the door control receiver receives the key signal; 2) the door control receiver sends a signal to the certification ECU; 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motors; and 4) the power window regulator motor assemblies are activated.
  2. When the driver door key cylinder (key-linked switch) is turned: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motors; and 3) the power window regulator motor assemblies are activated.

INSPECTION PROCEDURE

HINT:
Since the power window control system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.


1. CHECK BASIC FUNCTION (WIRELESS AND POWER DOOR LOCK CONTROL SYSTEM)
  1. Check that the wireless transmitter and driver door key cylinder (key-linked switch) lock and unlock all the doors normally (Click here).

    Result 
    Result
    Proceed to
    Transmitter and driver door key cylinder operate normally
    A
    Transmitter does not operate normally (w/ Entry and Start System)
    B
    Transmitter does not operate normally (w/o Entry and Start System)
    C
    Driver door key cylinder does not operate normally
    D



B
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) (Click here)

C
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) (Click here)

D
GO TO POWER DOOR LOCK CONTROL SYSTEM (Proceed to Problem Symptoms Table) (Click here)
A


2. CHECK MANUAL UP/DOWN FUNCTION
  1. Check that the manual up/down function using the multiplex network master switches and power window regulator switch can operate all the power windows (Click here).

    OK:
    Manual up/down function is normal.



NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) (Click here)
OK


3. CHECK REMOTE UP/DOWN FUNCTION
  1. Check that the remote up/down function using the multiplex network master switch operates the power windows (Click here).

    OK:
    Remote up/down function is normal.



NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) (Click here)
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter (Aug 2013 – Jul 2014)Key-off Operation Function Operates even if Operating Conditions are not Satisfied (Aug 2013 – Jul 2014) →