2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Key-off Operation Function Operates even if Operating Conditions are not Satisfied

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When the front doors are closed, each power window regulator motor can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (instrument panel junction block). However, when approximately 43 seconds have elapsed, or a front side door is opened within approximately 43 seconds of the ignition switch being turned off, all the power window regulator motors disable manual operation.
  1. During the auto function operation, when 43 seconds have elapsed and key-off operation is prohibited, the window operation stops immediately.
  1. The front passenger side power window and the rear power windows cannot be operated when the window lock switch is on.

INSPECTION PROCEDURE


1. CHECK LIN COMMUNICATION SYSTEM
  1. Check for LIN communication system DTCs related to the power window control system (Click here).

    OK:
    LIN communication system DTCs are not output.



NG
GO TO LIN COMMUNICATION SYSTEM (Click here)
OK


2. CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF
  1. Check the power window operation function after the ignition switch is turned off (Click here).

    Result 
    Result
    Proceed to
    Front side door is opened within 43 sec. but power windows can still operate
    A
    43 sec. pass and power windows can still operate
    B



B
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
A


3. READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH)
  1. Use the Data List to check if the main body ECU (multiplex network body ECU) is functioning properly (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FL Door Courtesy SW
    Front door courtesy light switch LH signal / ON or OFF
    ON: Front door LH closed
    OFF: Front door LH open
    -
    FR Door Courtesy SW
    Front door courtesy light switch RH signal / ON or OFF
    ON: Front door RH closed
    OFF: Front door RH open
    -

    OK:
    On tester screen, each item changes between ON and OFF according to above chart.



NG
Go to step 4
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)

4. CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Open a front door and check that the map light illuminates (Click here).

    OK:
    Map light illuminates.



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK


5. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
  1. Temporarily replace the driver side junction block with a new or normally functioning one.

  1. Check the front door open and close function.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (DRIVER SIDE JUNCTION BLOCK ASSEMBLY IS DEFECTIVE)


← All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter (from Aug 2014)Key-off Operation Function Operates even if Operating Conditions are not Satisfied (from Aug 2014) →