HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the following procedures to troubleshoot the seat belt warning system.
- *: Use the intelligent tester.
- Use the following procedures to troubleshoot the seat belt warning system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK FOR DTC* |
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC.
Result Result
Proceed to
DTC is not output
A
CAN communication system DTC is output (for LHD with Entry and Start System)
B
CAN communication system DTC is output (for LHD without Entry and Start System)
C
CAN communication system DTC is output (for RHD with Entry and Start System)
D
CAN communication system DTC is output (for RHD without Entry and Start System)
E
Airbag system DTC is output
F
|
|||||
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 6.REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||