2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FAN AND GENERATOR V BELT

  1. A099194E01
    Use the hexagonal part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the V belt. Then remove the V belt.

    NOTICE:
    When removing the V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


2. REMOVE TENSIONER PULLEY

NOTICE:
Perform the following procedure when it is necessary to replace the tensioner pulley.

  1. G035081E06
    Remove the bolt, dust seal and tensioner pulley.

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →