2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Starter Signal Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the engine is cranked, the intake air flow becomes slow so fuel vaporization is poor. A rich mixture is therefore necessary in order to achieve good startability. While the engine is being cranked, the battery voltage is applied to terminal STA of the ECM. The starter signal is mainly used to increase the fuel injection volume for starting and after-start injection control.

WIRING DIAGRAM

A227979E05

INSPECTION PROCEDURE


When using intelligent tester:


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.

  1. Read the STA signal on the intelligent tester while the starter operates.

    OK:
    Ignition Switch Position
    Starter SIG
    LOCK, ACC, ON
    OFF
    START
    ON



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (CLUTCH START SWITCH - ECM)
  1. Disconnect the clutch start switch connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    A40-1 - G61-11 (STA)
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    r1-1 - G61-11 (STA)
    Always
    Below 1 Ω


    Standard Resistance (Check for Short):
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    A40-1 or G61-11 (STA) - Body ground
    Always
    10 kΩ higher
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    r1-1 or G61-11 (STA) - Body ground
    Always
    10 kΩ higher

  1. Reconnect the clutch start switch connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← ECM Power Source Circuit (from Aug 2014)Starter Signal Circuit (from Aug 2014) →