2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

NOTICE:
When working with seal packing material, perform the following:
  1. Using a razor blade and gasket scraper, remove all old seal packing material from the gasket surfaces.
  2. Clean all components thoroughly to remove all foreign matter.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply seal packing material in a continuous line approximately 2 to 3 mm (0.0787 to 0.118 in.) in diameter on the sealing surface.
  5. Reassemble parts within 10 minutes of applying seal packing material. Failing to do so will require the seal packing material to be removed and reapplied.


1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF, and install it to the transmission wire.

  1. Install the transmission wire to the case, and install the stopper plate with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


2. CONNECT TRANSMISSION WIRE

  1. C212457E04
    Connect the 4 connectors to the 4 shift solenoid valves.
    Text in Illustration 
    *a
    White
    *b
    Black
    *c
    Orange/Green
    *d
    Yellow/Brown

  1. Connect the temperature sensor with temperature sensor clamp and the bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D005554E02
  1. Install 3 new gaskets.

  1. D028706E04
    Install the oil strainer with the 4 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.

    14 mm (0.55 in.) for bolt A
    20 mm (0.79 in.) for bolt B
    23 mm (0.91 in.) for bolt C


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C213709E01

HINT:
Remove any packing material and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install the 3 magnets to the locations indicated in the illustration.

    Text in Illustration 
    *1
    Magnet

  1. AT01362E07
    Apply seal packing to the oil pan as shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1281,
    Three Bond 1281 or equivalent
    Seal diameter:
    2 to 3 mm (0.0787 to 0.118 in.)

  1. Install the oil pan with the 19 bolts.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }


5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

C213708
  1. Coat a new O-ring with ATF, and install it to the oil filler tube.

  1. Install the oil filler tube to the transmission with the 2 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Install the oil dipstick.


6. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF WS


7. INSPECT AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid (Click here).

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →