2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT TRANSMISSION WIRE (NO. 1 ATF TEMPERATURE SENSOR)

C214964E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (OT2+) - 5 (OT2-)
    Always
    79 Ω to 156 kΩ
    1 (OT2+) - Body ground
    Always
    10 kΩ or higher
    5 (OT2-) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Wire)

    HINT:
    If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

    Standard Resistance:
    ATF Temperature
    Specified Condition
    10°C (50°F)
    5 to 8 kΩ
    25°C (77°F)
    2.5 to 4.5 kΩ
    110°C (230°F)
    0.22 to 0.28 kΩ

    If the result is not as specified, replace the transmission wire.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →