2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


2. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

C213708
  1. Remove the transmission oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.


3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C212456
  1. Remove the 19 bolts.

  1. Q007487E04
    Insert oil pan seal cutter between the transmission case and oil pan. Cut through the seal and remove the oil pan.

    NOTICE:
    1. Be careful not to damage the oil pan flange.
    2. Some fluid will remain in the oil pan. Carefully remove the oil pan.

  1. Examine the particles in the oil pan.

    1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bush wear


4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

D028706E02
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid may leak out of the oil strainer.

  1. Remove the 3 gaskets from the oil strainer.


5. DISCONNECT TRANSMISSION WIRE

C212457
  1. Remove the bolt and temperature sensor clamp, and disconnect the temperature sensor.

  1. Disconnect the 4 connectors from the 4 shift solenoid valves.


6. REMOVE TRANSMISSION WIRE

G036410E01
  1. Remove the bolt and stopper plate from the case.

  1. Pull out the transmission wire from the transmission case.

  1. Remove the O-ring from the transmission wire.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →