2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

D029376E01

  1. Inspect the 1-way clutch.

    1. Install SST to the inner race of the 1-way clutch.

      SST
      09350-32014   (09351-32010)

    2. Set SST so that it fits in the notch of the converter hub and in the outer race of the 1- way clutch.

      SST
      09350-32014   (09351-32020)

    3. D029377E04
      With the torque converter standing on its side, check that the clutch locks when SST is turned counterclockwise and rotates freely and smoothly when SST is turned clockwise.
      Text in Illustration 
      V100135
      Lock
      V100136
      Free
      If the results are not as specified, clean the converter and recheck the 1-way clutch.
      If the results still are not as specified even after cleaning the converter, replace the converter.

  1. C197457E02
    Determine the condition of the torque converter clutch.
    Text in Illustration 
    *1
    Sample showing maximum allowable amount of powder in ATF

    1. Check that the following conditions are met:

      1. During the stall test or when the shift lever is in N, metallic sounds are not emitted from the torque converter clutch.
      2. The 1-way clutch turns in one direction and locks in the other direction.
      3. The amount of powder in the ATF is not more than the sample shown in the illustration.
      If the results are not as specified, replace the torque converter clutch assembly.

      HINT:
      The sample illustration shows approximately 0.025 liters (0.026 US qts, 0.022 Imp. qts) of ATF taken from a removed torque converter clutch.

  1. Replace the ATF in the torque converter clutch.

    1. If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter clutch thoroughly and drain the ATF with the torque converter facing upward.

  1. Clean and check the oil cooler and oil pipe line.

    1. If the torque converter clutch is inspected or the ATF is replaced, clean the oil cooler and oil pipe line.

      HINT:
      1. Apply compressed air of 196 kPa (2 kgf/cm2, 28 psi) into the inlet hose.
      2. If a large amount of powder is found in the ATF, add new ATF using a bucket pump and clean the oil cooler and oil pipe line again.

    2. If the ATF is cloudy, inspect the oil cooler (radiator).

  1. D025368E29
    Prevent deformation of the torque converter clutch and damage to the oil pump gear.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect
    *c
    Bottom is damaged

    1. When any marks due to interference are found on the end of a bolt for the torque converter clutch and on the bottom of the bolt hole, replace the bolt and torque converter clutch.

    2. Make sure all of the bolts are the same length.

    3. Make sure no spring washers are missing.


INSPECT DRIVE PLATE
  1. Check the drive plate for damage.

  1. C191483E02
    Set up a dial indicator and measure the runout of the 6 portions around the torque converter clutch contact surfaces.

    Maximum runout:
    0.30 mm (0.0118 in.)

    Text in Illustration 
    *1
    Measuring point
    If the runout is more than the maximum, or the drive plate is damaged, replace the drive plate (Click here).

← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →