2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Terminals TC and CG are located in the DLC3.
The DLC3 is located under the instrument panel under cover. When terminals TC and CG are connected, DTCs in normal mode or test mode can be read from the Malfunction Indicator Lamp (MIL) in the combination meter assembly.
Also, terminal SIL is located in the DLC3. This terminal is used for M-OBD communication with the intelligent tester.

WIRING DIAGRAM

A119281E03

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK DLC3 (CHECK VOLTAGE)

  1. A143005E05
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G48-16 (BAT) - G48-4 (CG)
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to DLC3)



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (ECM - DLC3)
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    G61-15 (SIL) - G48-7 (SIL)
    Always
    Below 1 Ω
    G61-4 (TC) - G48-13 (TC)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Connection
    Condition
    Specified Condition
    G61-15 (SIL) or G48-7 (SIL) - Body ground
    Always
    10 kΩ or higher
    G61-4 (TC) or G48-13 (TC) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)

3. CHECK DLC3

  1. A143005E06
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    G48-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to DLC3)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BATTERY)


← TC and CG Terminal Circuit (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →