Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
Terminals TC and CG are located in the DLC3. The DLC3 is located under the instrument panel under cover. When terminals TC and CG are connected, DTCs in normal mode or test mode can be read from the Malfunction Indicator Lamp (MIL) in the combination meter assembly. Also, terminal SIL is located in the DLC3. This terminal is used for M-OBD communication with the intelligent tester.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK DLC3 (CHECK VOLTAGE)
Measure the voltage according to the value(s) in the table below.