2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for Automatic Transmission)

NOTICE:
  1. This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal sensor assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.
  2. Prevent physical shocks to the accelerator pedal.
  3. Do not disassemble the accelerator pedal assembly.

  1. Install the accelerator pedal with the 3 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal connector.


2. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY (for Manual Transmission)

NOTICE:
  1. This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal sensor assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.
  2. Prevent physical shocks to the accelerator pedal.
  3. Do not disassemble the accelerator pedal assembly.

  1. Install the accelerator pedal with the 2 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal connector.


3. INSTALL FRONT NO. 1 CONSOLE BOX INSERT
  1. Attach the 2 clips and guide to install the front No. 1 console box insert.


4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.

  1. Install the screw.

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →