2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B238138
    Remove the screw and No. 1 instrument panel under cover.

  1. Detach the 2 clips and 2 guides and remove the No. 1 instrument panel under cover.


2. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

B238139
  1. Detach the 2 clips and guide and remove the front No. 1 console box insert.


3. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for Automatic Transmission)

NOTICE:
This accelerator pedal does not require lubrication.
Do not apply oil or other lubrication to the accelerator pedal sensor assembly.
If applied, the accelerator pedal sensor assembly must be replaced.

  1. A222079
    Disconnect the accelerator pedal connector.

  1. Remove the 3 nuts and accelerator pedal.

    NOTICE:
    1. Prevent physical shocks to the accelerator pedal.
    2. Do not disassemble the accelerator pedal assembly.


4. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY (for Manual Transmission)

NOTICE:
This accelerator pedal does not require lubrication.
Do not apply oil or other lubrication to the accelerator pedal sensor assembly.
If applied, the accelerator pedal sensor assembly must be replaced.

  1. A222078
    Disconnect the accelerator pedal connector.

  1. Remove the 2 nuts and accelerator pedal.

    NOTICE:
    1. Prevent physical shocks to the accelerator pedal.
    2. Do not disassemble the accelerator pedal assembly.

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →