2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Front Fog Light Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The main body ECU receives headlight dimmer switch information signals and illuminates the front fog lights.

WIRING DIAGRAM

E199765E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FRONT FOG LIGHT RELAY)
  1. Using the intelligent tester, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front fog light relay
    ON/OFF
    The headlight dimmer switch is in the tail position.

    OK:
    Front fog light relay operates (front fog lights come on).



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Remove the driver side junction block with its connectors still connected (Click here).

  1. E202228E02
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    2F-9 - Body ground
    Headlight dimmer switch in tail and front fog light switch on
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (Driver Side Junction Block Assembly)



NG
Go to step 3
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - FOG LIGHT ASSEMBLY)

3. INSPECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY

  1. E285938E01
    Remove the driver side junction block assembly (Click here).

  1. Remove the main body ECU from the driver side junction block assembly (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2F-9 - Body ground
    Apply battery positive (+) to 2K-1, and battery negative (-) to A-13 and A-14
    11 to 14 V
    Always
    Below 1 V



NG
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Front Fog Light Circuit (Aug 2013 – Jul 2014)Rear Fog Light Circuit (Aug 2013 – Jul 2014) →