2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL REAR CRANKSHAFT OIL SEAL

  1. A057268E02
    Apply MP grease to the lip of a new oil seal.

    NOTICE:
    Keep the lip free from foreign matter.

  1. Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07100)

    NOTICE:
    Wipe off any extra grease on the crankshaft.


2. INSTALL FLYWHEEL HOUSING DUST SEAL

3. INSTALL REAR END PLATE
  1. Install the rear end plate with the 2 bolts.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }


4. INSTALL FLYWHEEL SUB-ASSEMBLY

A058716E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Clean the bolts and bolt holes.

  1. Apply adhesive to 2 or 3 threads of each of the bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the flywheel to the crankshaft.

  1. Temporarily install the flywheel with the 8 bolts.

  1. A058717E01
    Tighten the 8 bolts uniformly in several steps in the order shown in the illustration.

    Torque:
    123 N*m{ 1249 kgf*cm , 90 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installing.


5. INSTALL CLUTCH DISC ASSEMBLY

  1. C215524E01
    Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.
    SST
    09301-00110  
    Text in Illustration 
    V100135
    Flywheel Side

    NOTICE:
    Be sure to install the clutch disc so that it is facing in the correct direction.


6. INSTALL CLUTCH COVER ASSEMBLY

C215525E02
  1. Align the matchmarks on the clutch cover and flywheel.

    Text in Illustration 
    *a
    Matchmark

  1. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    HINT:
    Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.


7. INSTALL MANUAL TRANSMISSION ASSEMBLY
  1. Install the manual transmission (Click here).

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →