2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE MANUAL TRANSMISSION ASSEMBLY
  1. Remove the manual transmission (Click here).


2. REMOVE CLUTCH COVER ASSEMBLY

  1. C215521E01
    Place matchmarks on the clutch cover and flywheel.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


3. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.


4. REMOVE FLYWHEEL SUB-ASSEMBLY

A058716E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Remove the 8 bolts and flywheel.


5. REMOVE REAR END PLATE
  1. Remove the 2 bolts and rear end plate.


6. REMOVE FLYWHEEL HOUSING DUST SEAL

7. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A057267E03
    Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *a
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    After the removal, check that the crankshaft is not damaged. If damaged, repair it with a sandpaper (#400).

    HINT:
    Tape the screwdriver before use.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →