2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

TERMINALS OF ECU

System information · Vehicles built from Aug 2013


COMBINATION METER ASSEMBLY
E201228E02
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G6-5 (ET) - Body ground*1
    G - Body ground
    Ground
    Always
    Below 1 Ω
    G6-6 (SW1) - Body ground
    B - Body ground
    Power source for light control rheostat
    Ignition switch ON
    4.6 to 5.4 V
    G6-7 (SW2) - Body ground
    GR - Body ground
    Light control rheostat signal
    Light control rheostat fully turned right
    Below 1 Ω
    Light control rheostat fully turned left
    8 to 12 kΩ
    G6-8 (L) - Body ground*1
    W - Body ground
    Fuel sender gauge signal
    Fuel F (full tank) → E (empty)
    Below 1 V → 4.5 to 9 V
    G6-9 (L) - Body ground
    B - Body ground
    Fuel sender gauge signal
    Fuel F (full tank) → E (empty)
    Below 1 V → 4.5 to 9 V
    G6-10 (TC) - Body ground*2
    W - Body ground
    TAIL cancel switch signal
    TAIL cancel switch on
    Below 1 Ω
    TAIL cancel switch off
    1 MΩ or higher
    G6-11 (RSET) - Body ground
    P - Body ground
    ODO/TRIP switch signal
    Ignition switch ON, ODO/TRIP switch on (Pushed)
    Below 1 Ω
    Ignition switch ON, ODO/TRIP switch off (Not pushed)
    1 MΩ or higher
    G6-13 (BLP) - Body ground*3
    R - Body ground
    Back-up light switch signal
    Ignition switch ON, Back-up light switch on
    11 to 14 V
    G6-14 (ST) - Body ground*3
    W - Body ground
    Starter signal
    Clutch start switch on, Cranking
    5.5 V or higher
    G6-15 (TCO) - Body ground*4
    V - Body ground
    DLC3 (TC)
    Ignition switch ON
    11 to 14 V
    G6-19 (B) - Body ground
    Y - Body ground
    Turn signal LH
    Ignition switch ON, turn LH indicator light blinks
    Below 1 V ←→ 11 to 14 V
    Ignition switch ON, turn signal switch neutral position
    Below 1 V
    G6-20 (B) - Body ground
    G - Body ground
    Turn signal RH
    Ignition switch ON, turn RH indicator light blinks
    Below 1 V ←→ 11 to 14 V
    Ignition switch ON, turn signal switch neutral position
    Below 1 V
    G6-21 (E2) - Body ground
    BR - Body ground
    Signal ground
    Always
    Below 1 V
    G6-22 (SW3) - Body ground
    LG - Body ground
    Light control rheostat ground
    Always
    Below 1 V
    G6-23 (FE) - Body ground*1
    B - Body ground
    Fuel sender gauge ground
    Always
    Below 1 Ω
    G6-24 (E) - Body ground
    W - Body ground
    Fuel sender gauge ground
    Always
    Below 1 Ω
    G6-26 (B) - Body ground
    L - Body ground
    Battery
    Always
    11 to 14 V
    G6-28 (IG+) - Body ground
    R - Body ground
    Ignition switch signal
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    G6-30 (CHG-) - Body ground
    P - Body ground
    Charge warning light signal
    Ignition switch ON, charge warning light on
    Below 1 V
    Ignition switch ON, charge warning light off
    11 to 14 V
    G6-31 (SW) - Body ground
    P - Body ground
    Fluid level warning switch signal
    Ignition switch ON, fluid level warning switch on
    Below 1 V
    Ignition switch ON, fluid level warning switch off
    11 to 14 V
    G6-32 (+S) - Body ground
    R - Body ground
    Speed signal for other systems (Output)
    Ignition switch ON, front wheel turns slowly
    Pulse generation
    (See waveform 1)
    G6-33 (SI) - Body ground
    V - Body ground
    Speed signal for other systems (Input)
    Ignition switch ON, front wheel turns slowly
    Pulse generation
    (See waveform 1)
    G6-34 (S) - Body ground*4
    P - Body ground
    Engine speed signal
    Idling with warm engine
    Pulse generation
    (See waveform 2)
    G6-35 (TEMP) - Body ground*4
    L - Body ground
    Engine coolant temperature signal
    Idling with warm engine
    Pulse generation
    (See waveform 3)
    G6-37 (LIN) - Body ground
    GR - Body ground
    LIN communication signal
    Ignition switch ON
    Pulse generation
    G6-39 (CANL) - Body ground
    W - Body ground
    CAN communication signal
    Ignition switch off
    200 Ω or higher
    G6-40 (CANH) - Body ground
    LG - Body ground*6, *7, *8
    CAN communication signal
    Ignition switch off
    200 Ω or higher
    V - Body ground*9, *10
    G7-1 (ED) - Body ground*11
    W-B - Body ground
    Vehicle type
    for 3 door
    Below 1 V
    for 5 door
    4.6 to 5.4 V
    G7-3 (S) - Body ground*4, *12
    R - Body ground
    Fuel sedimenter warning switch signal
    Ignition switch ON, fuel sedimenter warning switch on
    Below 1 V
    Ignition switch ON, fuel sedimenter warning switch off
    11 to 14 V
    G7-4 (FFTR) - Body ground*12
    V - Body ground
    Fuel filter warning switch signal
    Ignition switch ON, fuel filter warning switch on
    Below 1 V
    Ignition switch ON, fuel filter warning switch off
    11 to 14 V
    G7-5 (OIL) - Body ground*12, *13
    G - Body ground
    Oil level sensor signal
    Ignition switch ON, oil level warning light comes on
    Below 1 V
    Ignition switch ON, oil level warning light off
    11 to 14 V
    G7-7 (CHK) - Body ground
    V - Body ground
    MIL (Malfunction Indicator Lamp) signal
    Ignition switch ON, MIL (Malfunction Indicator Lamp) comes on
    Below 1 V
    Ignition switch ON, MIL (Malfunction Indicator Lamp) off
    11 to 14 V
    G7-8 (GLW-) - Body ground*4
    R - Body ground
    GLOW indicator light signal
    Ignition switch ON, GLOW indicator light comes on
    Below 1 V
    Ignition switch ON, GLOW indicator light off
    11 to 14 V
    G7-15 (P/SB) - Body ground
    L - Body ground
    Passenger side seat belt buckle switch
    Ignition switch ON, sit on the front passenger seat, and front passenger side seat belt unfastened
    11 to 14 V
    Ignition switch ON, sit on the front passenger seat, and front passenger side seat belt fastened
    Below 1 V
    G7-16 (TIRE) - Body ground*14
    Y - Body ground
    Tire pressure warning light signal
    Ignition switch ON, tire pressure warning light off
    3.2 V or higher
    Ignition switch ON, tire pressure warning light on
    0.9 to 3.2 V
    G7-17 (EC) - Body ground*14
    BR - Body ground
    Tire pressure warning light ground
    Always
    Below 1 Ω
    G7-20 (WLVL) - Body ground*5
    W - Body ground
    Washer level warning signal
    Ignition switch ON, level warning switch on
    Below 1 V
    Ignition switch ON, level warning switch off
    11 to 14 V
    G7-23 (VCM) - Body ground*4
    G - Body ground
    Vacuum warning switch signal
    Ignition switch ON, vacuum warning switch on
    Below 1 V
    Ignition switch ON, vacuum warning switch off
    11 to 14 V
    G7-24 (S) - Body ground
    V - Body ground
    Oil pressure switch signal
    Ignition switch ON, oil pressure warning light on
    Below 1 V
    Ignition switch ON, oil pressure warning light off
    11 to 14 V
    1. *1: for Double Tank Type
    2. *2: w/ TAIL Cancel Switch
    3. *3: for Manual Transmission
    4. *4: for 5L-E
    5. *5: for Cold Area
    6. *6: for RHD
    7. *7: for LHD, 1GR-FE
    8. *8: for LHD, 1KD-FTV
    9. *9: for LHD, 2TR-FE
    10. *10: for LHD, 5L-E
    11. *11: except 5L-E
    12. *12: for 1KD-FTV
    13. *13: for Europe, 1GR-FE
    14. *14: w/ Tire Pressure Monitor System

  2. I043789E03
    Waveform 1 (Reference): Using an oscilloscope:
    Item
    Condition
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Vehicle condition
    Driving at approximately 20 km/h (12 mph)

    HINT:
    When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

  3. A110546E06
    Waveform 2 (Reference): Using an oscilloscope:
    Item
    Condition
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Vehicle condition
    Idling with warm engine

  4. A105099E06
    Waveform 3 (Reference): Using an oscilloscope:
    Item
    Condition
    Tool setting
    5 V/DIV., 0.1 sec./DIV.
    Vehicle condition
    Idling


COMBINATION METER ASSEMBLY INNER CIRCUIT (for Optitron Meter)
E283903E01
E283904E01
E283908E01
E201430E07

COMBINATION METER ASSEMBLY INNER CIRCUIT (for Analog Meter, except 5L-E)
E283903E01
E283905E01
E283908E02
E201430E08

COMBINATION METER ASSEMBLY INNER CIRCUIT (for Analog Meter, for 5L-E)
E283906E01
E283907E01
E284895E01
Terminal No. (Symbol)
Wire Harness Side
G6
1
-
2
-
3
-
4
-
5 (ET)
Ground
6 (SW1)
TRIP switch (Light control rheostat)
7 (SW2)
TRIP switch (Light control rheostat)
8 (L)*1
Fuel sender gauge assembly
9 (L)
Fuel sender gauge assembly
10 (TC)*2
TRIP switch (TAIL cancel switch)
11 (RSET)
ODO/TRIP switch
12
-
13 (BLP)*3
Back-up light switch
14 (ST)*4
ST relay, clutch start switch
15 (TCO)*4
DLC3
16
-
17
-
18
-
19 (B)
Turn signal flasher assembly
20 (B)
Turn signal flasher assembly
21 (E2)
Ground
22 (SW3)
TRIP switch (Light control rheostat)
23 (FE)*1
Fuel sender gauge assembly
24 (E)
Fuel sender gauge assembly
25
-
26 (B)
Battery
27
-
28 (IG+)
Ignition switch
29
-
30 (CHG-)
Generator
31 (SW)
Fluid level warning switch
32 (+S)
Each part that uses the vehicle speed signal
33 (SI)
Skid control ECU
34 (S)*4
ECM
35 (TEMP)*4
ECM
36
-
37 (LIN)*5
Accessory meter
38
-
39 (CANL)
CAN communication line
40 (CANH)
CAN communication line
G7
1 (ED)*6
Ground
2
-
3 (S)*4, *7
Fuel sedimenter warning switch
4 (FFTR)*7
Fuel filter warning switch
5 (OIL)*7, *8
Oil Level Sensor
6
-
7 (CHK)
ECM
8 (GLW-)*4
ECM
9
-
10
-
11
-
12
-
13
-
14
-
15 (P/SB)
Passenger side seat belt buckle switch
16 (TIRE)*9
Tire pressure monitor receiver assembly
17 (EC)*9
Tire pressure monitor receiver assembly
18
-
19
-
20 (WLVL)*10
Level warning switch assembly
21
-
22
-
23 (VCM)*4
Vacuum warning switch
24 (S)
Oil pressure switch
  1. *1: for Double Tank Type
  2. *2: w/ TAIL Cancel Switch
  3. *3: for Manual Transmission
  4. *4: for 5L-E
  5. *5: w/ Multi-function Switch
  6. *6: except 5L-E
  7. *7: for 1KD-FTV
  8. *8: for Europe, 1GR-FE
  9. *9: w/ Tire Pressure Monitor System
  10. *10: for Cold Area
← PROBLEM SYMPTOMS TABLE (from Aug 2014)DTC CHECK / CLEAR (from Aug 2013) →