2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE VISCOUS HEATER RELAY

E283857E01
  1. Remove the viscous heater relay from the engine room relay block.

    Text in Illustration 
    *1
    Viscous Heater Relay


INSPECT VISCOUS HEATER RELAY

B060778E97
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the viscous heater relay.


INSTALL VISCOUS HEATER RELAY
  1. Install the viscous heater relay to the engine room relay block.

← INSTALLATION (from Aug 2014)ON-VEHICLE INSPECTION (from Aug 2013) →