ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| REMOVE MAGNET CLUTCH RELAY |
![]() ![]() |
Remove the magnet clutch relay from the engine room relay block.
Text in Illustration *1
Magnet Clutch Relay
| INSPECT MAGNET CLUTCH RELAY |
![]() ![]() |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Battery voltage not applied between terminals 1 and 2
10 kΩ or higher
Battery voltage applied to terminals 1 and 2
Below 1 Ω
- If the result is not as specified, replace the magnet clutch relay.
| INSTALL MAGNET CLUTCH RELAY |
Install the magnet clutch relay to the engine room relay block.



